How to install the led light strip correctly:

1. Since the light strip is a module per meter, it is not easy to harm the power circuit when it is disconnected from the cut. If you break it casually, a module will not light up.

2. Connect the power plug: The LED itself is a diode and is driven by a DC power supply, so there are positive and negative. If the power plug is not lit, only the other end of the light strip must be removed.

3. The placement of the light strip: the light strip is packaged in reel, the newly disassembled light strip will be distorted, and it is not easy to install. It can be sorted and leveled first, and then it can be placed in the light strip. Because the light strip is a single layer of light, if it is not leveled, the light-dark boundary line will be uneven, especially at the corners.

4. When the LED light strip is a roll, please do not illuminate the light strip.

5. When installing, please bend the lamp belt to one side, exposing 2-3MM copper core wire, and cut it neatly with cutting pliers, do not leave burrs to prevent short circuit failure.

6. To install the LED light strip under severe cold temperature, you can plug in the power for a few minutes to loosen the light body and be easy to bend, and then turn off the power for installation.

7. Do not use the express switching power supply during the whole process of installing or installing the light belt, only the connection, installation and proper conditions can be connected to the switching power supply

8. During the whole process of installation and application, do not knock the led tube with heavy objects, or it will vibrate.

9. The tail of the led tube must be tightly glued with a tail plug before putting it on.

10. Only two LED tubes with the same specifications and models and the same working voltage can be connected in series, and the total length of the series cannot exceed the approved application level.

11. The sockets must be sturdy and free from short-circuit failure safety hazards. When installing outdoors, the joints must be sealed with structural glue or other appropriate methods to ensure that the joints see water.

12. Can not be installed in water, inflammable, flammable and explosive natural environment, it is necessary to ensure that the natural environment is well ventilated.

13. Do not install and fix the led tube tightly with metal composite materials such as thin iron wire to prevent the thin iron wire from sinking deep into the led tube, causing short damage to the led tube.

14. The power supply voltage should be the same as that of the led tube, and proper safety devices should be installed.

15. During the whole process of LED tube application, do not wrap it with everything to cover the LED tube.

16. When you find that the body of the led tube is damaged, please cut off this part immediately, and can't apply it again to prevent risk.

17. If you want actual effects such as flashing, water flow, etc., please use the LED control panel.

We are the professional manufacturer of led light strips, support OEM and ODM customization, and provide you with personalized lighting solutions. Welcome to contact and cooperate with us!